|
Maxell Plastic Emulsion is another product of Rainbow paint industries. It is a excellent quality emulsion paint with excellent application properties. It gives a smooth velvety finish and provides an extra edge in opacity and covering. It can be applied on walls , ceiling, old and new concrete plaster, chip board and hard board, Plastic Emulsion can be used on interior and exterior surface. This product is carefully formulated to suit the masonry work, Brick and Cement renderings.
Application Guide
New Concrete Surface
Sand down the plaster with Emery stone and apply one coat of Rainbow Perfecton Wall Primer Sealer. Then Prepare the surface by applying 2 coats of Rainbow Wall Putty prepared with Rainbow Perfecton Wall Primer Sealer. As new plastered surfaces are highly alkaline a coat of Rainbow Perfecton Wall Primer Sealer is recommended for better alkali resistance. Then apply 2 to 3 coats of Maxell Plastic Emulsion Paint, depending on the quality of wall.
Old Painted Surface
Remove all dust, Dirt and loose adhering or flaked paints by scarping. After scarping apply one coat of Rainbow Perfecton Wall Primer Sealer with slight over thinning, which will help the Sealer to penetrate into the surface. Then apply secong coat of Sealer which is followed by the Filling, For which Rainbow Wall Putty can be used. After the surface has been properly prepared apply 2 to 3 coats of Maxell Plastic Emulsion.
Colour Range: As per Maxell Plastic Emulsion Shade Card or as required. | Covering Capacity: Maxell Plastic Emulsion covers approximately 275-300 sq ft/3.64 Ltrs. |
Film Tickness: 25-30 micron per coat. | Number of Coats: 2-3 on prepared surface |
Composition: Based on high quality polyvinyl acetate, acrylate resin combined with pigments and carefully selected extenders. | Thinner: Water 1:1 |
Application: The paint can be applied by Brush, Roller and Spray- by thinning with equal volume of water for better adhesion and penetration, first coat should be thinned slightly more than normal. | Drying Time: Maxell Plastic Emulsion dries with ½ hours to a smooth finish, Allow to dry ½ hours before recoating under humid condition the drying time could be retarded and hence would require a long time to dry.So we recomend that you Recoat it after 2 hours. |
Gloss: Matt with silky finish | Packing: 0.91 Ltrs, 3.64 Ltrs and 14.56 Ltrs |
|